JOFER SERVO TRAYS AND PARTS

[harryhackenbacker]

Half way through fitting now ,few Issues ,making sure the transmission is running perfect, you always get slight Quirbles swopping
trays around ,It's looking Awsome ,pics when done  

[harryhackenbacker]

Well fiished the trays today on the rally ,these are specials for use with the alloy carrier and alloy bearing holders ,basically a v4 set
in red with an EVO 3 brake plate to carrier hole position .As usual spot on fitting and superb quality, the only change I made was using
Elcon HT torx screws .  If you have a rally with std carrier and enclosed centre diff ,there is a set to fit that ,straight fit .

[Redline]

So yours didn't have the different stock tray and enclosed diff Mike?

[harryhackenbacker]

So yours didn't have the different stock tray and enclosed diff Mike?

Matt I junked the plastic enclosed centre diff holder ,the alloy holders are stronger ,more adjustable ,and offer a heat sink for Hot
bearings ,some times the old systems are best ,I am sure the plastic one is just a commercial thing ,cheaper to produce and faster to
fit in assembly 

[Rover Man]

Im liking the radio trays, But is there an option for standard size servo's ??

[harryhackenbacker]

Im liking the radio trays, But is there an option for standard size servo's ??

Dave ,the only trays I have seen are for the bigger servos ,do you run a smaller throttle/brake servo ?? or all three ,be worth doing
to Improve the steering  and just use one platic size reducer or fabricate one ,or even PM jofer himself 

[Rover Man]

Use standard size servo's all round. Bigger isnt always better 

And using the plastic adapptors means i may as well keep the plastic tray.

The only thing i thought is to make some size reducers out of carbon but would rather have the alloy tray
with standard size servo holes. 

[banngass]

Cheers you too    one more part needed a tray for the top of the tank to replace the plastic one and make a solid link
from the engine bolt to the rear tower,perhaps Pink  

What is status on this part? Is is out in the shops by now?

[BeatsMe]

Don't think so mate, might have gone into the THB... 






Too Hard Basket   

[harryhackenbacker]

Last time I spoke to Jofer ,he said it would need to be made  in 3 parts to keep the cost down ,perhaps an updated Ultimate tank
supports system would be the answer ,but unless he has wholesale demand ,it won't happen .

[BeatsMe]

The demand is low and the unit cost will be high because no one would be willing to make a minimum of 1000 at a time.

[joferusa]

Banngass
Unfortunately the parts stand by
BeatsMe and harryhackenbacker is right.
maybe in the future come to the drawing board again
regards
joe

[harryhackenbacker]

Welcome , to Joe as a Sponsor , just dug this post up as the one that started "upper alloy fever "   
glad it did ,well happy with my parts 

[ticky]

Just like to say Big thanks to Jofer. Ordered my trays and fuel tank support Sunday and arrived Friday. Now thats quick considering how far they came. All the correct bolts included excellent service.

Ayaz

[joferusa]

Ayaz
good news you received your parts as quickly, honestly goes luck with USPS
sometimes it takes 1 week, sometimes two
other countries such as Russia apparently takes more, supposedly USPS site says the same time, but ...
I'm glad that you get this all right
thank you