New MCD Front Axle for CVD 2012 with O clip FT Grade

[gixxerp]

Hey Mike, Got one of these in the van



Ill pop over if you like  

that should do the trick

[printman]

   

[harryhackenbacker]

Hey Mike, Got one of these in the van



Ill pop over if you like  

that should do the trick


Dave ,saw  those for sale at screwfix , Under Size reduction tool for Losi Racing  

[Rover Man]

Thats where i got it from mike, Right next to the MCD repair kit



 

[harryhackenbacker]

Ha Ha    you just need deep pockets and skill in the workshop 

Mind !!!!! been Everywhere today for dremel accesories 5 fookin places !!!!! no luck managed to get some
expensive german bits from a machine and tool place ,and they won't fetch much off ,the one cvd still
jumps on lock    so fook it ,I will buy the whole thing ,when it comes out ,it would have been cheaper
in the first place , and I would have saved a Day and the stress 

[gixxerp]

anyone know if the FT drive cups are on sale anywhere yet?

[harryhackenbacker]

None about yet apart from on the factory team cars ,It's all a Question of who mcd send them to first ,
shipping times etc and quantities I would think 10 to england will be quicker than 200 to Robitronic ,
who knows !!!!!!  , just checked here

http://shop.robitronic.com/chassis/sparparts-options/mcd/v4-line/options-01-7/?lang=1

[RossMod]

anyone know if the FT drive cups are on sale anywhere yet?

We have the FT grade drive cups and spare clips in stock 

http://www.rossmod.co.uk/product/47240/MCD_Front_Axle_for_CVD_2012_with_O_clip_FT_Grade022100S1

[printman]

I think he means the FT Diff output cups 

[RossMod]

Ah I see sorry, we will get back to you once we have spoke with Sinan 

[harryhackenbacker]

Back on the CVD ft grade cups , after I got over my wobbler on the shaft mod ,and fitted the right bit to
my dremmel , all was good ,slight oversize on one bearing shoulder ,but Rossmod have just despatched
a replacement 

The bit set was great value for £12 !!!!!!

[RossMod]

Ok guys some information for you regarding the FT grade drive cups, we have spoken with Sinan and we have some on the way. approx 1 week, Here is the link

http://www.rossmod.co.uk/product/47370/MCD_Diff_Output_Coupling_Hex_012012_FT_Grade_021105S0

Also just to let you all now we have a Factory Team section on our website to make it easier for you guys to find all the new tuning parts, we hope we have made it easier to navigate our website, any comments are appreciated.

[harryhackenbacker]

Next day relacement CVD cup arrived !!! well happy can crack on now ,picture fitted to an alloy hub 

[CyberSarge]

Do you think there is enough room to fit drive shaft gaters Harry? It does look like there is 

[harryhackenbacker]

Yes I would say so just need the right length bottom bolt ,just ordered some from elcon